电流式感测器尿酸浓度检测 |
参考报价 |
无资料 |
无资料 |
无资料 |
|
     |
本电路为低功耗之电流输入电流输出,能感测的电流范围因输入端为低阻抗的关系,能量测的电流范围能从250pA~50uA。本电路共有48颗MOS,其中包含一个辅导放大器(OTA)、自体偏压放大器(OPA)与9颗低功率MOS,运用电流镜架构把输入电流复制到输出端,电路稳定度也不会随着溶液之等效阻抗而明显变动,使其能更稳定运作。利用电化学的安培法来量测葡萄糖氧化反应所产生的电流信号,输入电流式读出电路,做电流讯号处理,后端再以微控器处理电路输出讯号,并做数值的转换,转换成血糖值,最后显示在LCD上,完成一血糖机雏形。
应用领域:
血糖
尿酸
胆固醇
酒精浓度
专利取得 :
美国
中华民国
|
概述 |
8051 Core |
参考报价 |
无资料 |
无资料 |
无资料 |
|
     |
The 8051 has gained great popularity since its introduction and is estimated it is
used in a large percentage of all embedded system products.
The basic form of 8051 core includes several on-chip peripherals, like timers and
counters, additionally there are 128 bytes of on-chip data memory and up to 4K bytes of
on-chip program memory.
|
概述 |
UART Serial Interface Controller |
参考报价 |
无资料 |
300 MHz |
无资料 |
|
     |
UART compatible Serial Interface Controller with receive and transmit FIFOs and support for all standard bit rates from 9600 to 921600 baud.
Applications
UART Communications
RS232, RS422, RS485 etc.
Micro-controller interfacing
|
概述 |
I2C Master Serial Interface Controller |
参考报价 |
无资料 |
300 MHz |
无资料 |
|
     |
Master serial controller compatible with the popular Philips® I2C standard. Features a simple command interface and permits multiple I2C slaves to be controlled directly from ASIC device. Supports standard (100 kbits/s), fast (400 kbits/s) and custom data rates well above 4 Mbits/s. Setup and hold-times on the SDA pin are fully configurable.
Applications
Inter-chip board-level communications
Standard 2-wire comms between a wide range of peripherals, MCUs and COTs ICs
|
概述 |
I2C Slave Serial Interface Controller |
参考报价 |
无资料 |
300 MHz |
无资料 |
|
     |
Slave serial controller compatible with the popular Philips® I2C standard. Permits an I2C Master to communicate with your ASIC device via a set of user-defined config and status registers. Supports standard (100 kbits/s), fast (400 kbits/s) and custom rates in excess of 4 Mbits/s.
Applications
I2C slave communication via your ASIC
Inter-chip board-level communications
|
概述 |
DDR4 SDRAM Controller Core |
参考报价 |
无资料 |
无资料 |
无资料 |
|
     |
Double Data Rate 4 (DDR4) SDRAM Controller Core is designed for use in applications requiring high memory throughput, high clock rates and full programmability.
The core uses bank management modules to monitor the status of each SDRAM bank. Banks are only opened or closed when necessary, minimizing access delays. Up to 32 banks can be managed at one time.
The core supports all new DDR4 features, including: 3DS device configurations, write CRC, data bus inversion (DBI), fine granu-larity refresh, additive latency, per-DRAM addressability, and temperature controlled refresh.
|
概述 |
8-bit / 16-bit Flash memory controller |
参考报价 |
无资料 |
无资料 |
无资料 |
|
     |
FLASH memory controller ideal for interfacing to a wide range of parallel FLASH memory components . Features a fully synchronous command interface and a set of configurable timing parameters for compatibility with different devices.
Applications
Any application where non-volatile storage is required
Offline storage of parameters and data via your Chip
|
概述 |
车用电子开发平台 |
参考报价 |
无资料 |
无资料 |
无资料 |
|
     |
Single Chip Solution
Integrated Pressure Sensor
Integrated Acceleration Sensor
Integrated Temperature Sensor
32-bit RISC CPU
PWM
RF Transmitter (300-450 Mhz)
LF Receiver
Easy Integrated Customer’s Logic
Application
Tire Pressure Monitoring System
Automotive electronics
|
概述 |
1024X8 Flash |
参考报价 |
无资料 |
无资料 |
无资料 |
|
     |
Nor Flash can be used for code storage and data storage with general purpose MCUs and touch panel controller applications.Application in embedded system.
No additional Mask required on Standard CMOS process
|
概述 |
ASK/OOK Transmitter (R433) |
参考报价 |
无资料 |
无资料 |
无资料 |
|
     |
The IP is a high performance, easy to use, ASK Transmitter IP for remote wireless applications in the 300 to 450MHz frequency band. This transmitter IP is a true “data-in, antenna-out” monolithic device. R433 has three strong attributes: power delivery, operating voltage and operating temperature. In terms of power, the R433 is capable of delivering +10 dBm into a 50Ω load. This power level enables a small form factor transmitter (lossy antenna) such as a key fob transmitter to operate near the maximum limit of transmission regulations. In terms of operating voltage, the R433 operates from 1.8V to 3.6V.
Application
Garage Door Openers
Remote Controls
Home Automation
Sensor Networks
Security System
Fan Controllers
|
概述 |